Crown Molding "Attica Acanthus Leaf" 7-1/2 in. (CMW-017)

Crown Molding "Attica Acanthus Leaf" 7-1/2 in. (CMW-017)
  • These crown moldings are fully hand painted by a professional artist.
  • Finished in metallic colors to match chandeliers, lights fixture, ceiling fans and most of your place accessories.
  • Can be used for interior and exterior settings. Can also be washed.
  • These moldings are made of polyurethane that last forever.
  • Made in U.S.A.
  • Limited Lifetime Warranty.

 

As this is a custom hand painted product, please allow 2 to 3 weeks for shipping, (large orders may take longer). Thank you. 

  

If exterior setting is chosen a sealer coat should be applied for protection and durability, $5.00 will be added to the price.



Polyurethane Crown Molding    


Polyurethane is a hard, dense foam that has many advantages over wood in that it does not rot, crack, splinter, or absorb moisture.

Here are a few of the many advantages of polyurethane moldings:


  • Exquisite detail and design consistency.
  • Lasts longer than MDF or wood crown molding.
  • Designed for interior and exterior use.
  • Cuts cleanly without splintering.
  • Lightweight and easy to install.



FACE: The distance between the outer contact point with the ceiling to the bottom contact point with the wall.

HEIGHT: The distance between the ceiling and the bottom contact point with the wall.

WIDTH: The distance between the wall and outer contact point with the ceiling.

The FACE is the hypotenuse of the right triangle whose legs are the WIDTH and the HEIGHT.

White Crown Molding
White Molding Style:Attica Acanthus Leaf
White Molding Face:7-1/2 in.
White Molding Height:5-1/4 in.
White Molding Projection:5-1/4 in.
White Molding Length:94-1/2 in.
White Molding Material:Polyurethane
White Molding Weight:3.5 lb.
Suggested Ceiling Height:8 - 12 ft.

Write a review

Note: HTML is not translated!
    Bad           Good

Captcha

This specific crown molding can be installed in two ways, the traditional one (all corners wont be the same) and making all corners the same, in this case this crown molding should be installed differently than the other ones because of the design itself, in order to make all corners the same, installation must start right from the corners to the center of the wall, then figure out the closest design match where both pieces meet, if the distance between little corbels is to short consider take of one of them, if on the other hand it is too large, then using an oscilating tool a corbel can be cut from waste pieces and layed with glue, touch up migh be done after this.

This molding can also be installed on curved walls by cutting every section between little corbels in specific angle, for example: 3º bevel and 1º miter on both sides of the cut, a curved result can be obtained, see picture below.

  • Views: 1207
  • Product Code: CMW-017
  • Reward Points: 40
  • Availability: In Stock
  • $39.99
  • Price in reward points: 800
  • 20 or more $38.99
  • 50 or more $37.99
  • 100 or more $36.99

Available Options

Custom Hand Painted Finishes For Our White Products

We provide custom made hand painted finishes for all of our white products, we can match any color, finish, or decorative effect of your preference, just send us detailed information about the required finish or match while placing your order. We also have a vast variety of pre-made finishes available on this online store, view here.

Tags: CMW-017, Attica Acanthus Leaf Crown Molding 7-1/2 in.